Took a while to get this bolted on as it didn’t fit with the existing steering guard so I had to take that off. Will take an angle grinder to it soon and make them fit.
Wiring is now complete. Used 35mm2 welding cable run through 16mm convoluted tubing with bulkhead 
fittings to protect the wiring. Ran it from the battery box, along the chassis up to the wing behind the nearside headlight. Here it went into a heavy duty cutoff, then to the solenoids and finally on to the winch. A hole for the remote control socket was drilled through the wing above the light panel. Although mine was a four pin, only three were used. One +12v feed and then one to each solenoid.
No user commented on " New winch fitted "
Follow-up comment rss or Leave a TrackbackLeave A Reply